Advice on how to stick the sticker on the car correctly and remove the means to remove the car sticker. With tips to remove stickers from car paint. Many cars are decorated with stickers: the country code is emblazoned on the back, advertising messages are sometimes applied to the side and the bonnet can also be glued over a large area. But if you want to attach stickers to the car or simply remove them from there, you should follow a few basic rules.

If you want stickers on your car, you should moisten the car with soapy water on the affected area before sticking it on. The sticker can then be applied better. If you have enough of it later, you can loosen it again with a heat gun and a plastic spatula.

Stick the sticker correctly on the car

It sounds simple to just stick the sticker on the car. However, if you want to stick a stripe or something similar straight and without creases, you will usually face problems. It’s quite easy because the secret lies in the preparatory work: the sticker is to be stuck on a wet surface and can dry there if it is positioned correctly.

Take a bowl of water and dish soap. Clean the area where the sticker is to go as thoroughly as you can over a large area. Rinse the dirty water off the car carefully. Then wet the area again with soapy water. This does not damage the sticker, the dishwashing water cannot harm the adhesive.

Attach the sticker where you want it to go. Since it’s not sticky yet because of the water, you can slide it into place. You can now effortlessly smooth out air bubbles under the sticker. Allow the decal to dry in place. The water disappears by itself after a few minutes and the sticker adheres perfectly to its position.

Properly detach the sticker from the car

Once a sticker has really stuck to the car for a long time, it is difficult to remove it with just water and washing-up liquid. If you resort to harsher means, however, you run the risk of ruining the paintwork. Caution is, therefore, the top priority. You will need a heat gun and a plastic spatula. You can get both at the hardware store.

The heat gun should be turned to a warm but not hot setting. This is used to blow the warm air from about 10 centimeters onto the sticker until it bubbles. The sticker can now be scraped off with the plastic spatula without endangering the paintwork. The glued areas should then be cleaned with a soft sponge and soapy water.

Remove sticker residue from car paint

You can also easily remove sticker residue. In order to remove adhesive residues from stickers from the car paint, you should not use a chemical club. Good results can be achieved with butter: apply, leave to work, and remove the adhesive residue with a cloth.